You can request one or more extractions from this dialog.

There are three ways to select a net for extraction:

By Name - if you have created Net labels (in the label section) then you can specify one or more nets by entering the name. IF entering multiple names separate them with a comma.

By Node - if you have created Node labels (for example, A1, A2 ... for a package) you can specify the node by name. The net that the node touches will be extracted.

By Coordinate - if you do not have any labels or if you would prefer just to specify a coordinate you can do so. You must also then specify which stackup layer NETEX-G should use. Note: you can only specify one coordinate pair per extraction.

Extraction Dialog:     1   |   2   |   3   |   4   |   5   |   6   |   7   |